These top quality knot pullers will save your hands from line burns and painful spectra line cuts. Made from anodized T-6061 aluminum, there’s nothing torust or corrode.One plain rod, about 1″ wide and 5″ long. The second has a through-hole to fit 1/0 to 6/0 hook. The two are covered in an anti-slip covering and kept together for storage with strong magnets.

For Making Knots Between Lines

• Wrap ends of main line or leader around each rod three times.
• Center the knot in the middle of the two rods.
• Pull rods in opposite directions to cinch knot.

For Making Knots to Hooks

• Place hook through the through-hole.
• Wrap line around second rod three times.
• Pull rods in opposite directions to cinch knot.

Hooks not included